RAB bracket kit with 830 point solderless circuit, suitable and Arduino
- Ex Tax: $44.91
- Product Code: CN0041
- Availability: In Stock
This RAB Holder Kit provides you all the necessary components for a simple experiment, including a breadboard, quite a lot of jumper wires, an RAB holder, six LEDs, and six 1K current-limiting resistors, thus you can start the experiment right away.
With this kit, you can fix your Arduino board, Raspberry Pi, and breadboard on the RAB Holder, free of careless short circuits on a metal desk or caused by some metal parts underneath. What’s more, it also comes with 65pcs jumper wires with different length in various colors, therefore, you can just plug them into the control board and breadboard to build circuits, no bothering about complicated soldering.
Size: 200 x 135 mm (7.87 x 5.31 inch)
1 x RAB Holder
1 x 830-Point Breadboard
65 x Jumper Wire
1 x 20cm FC40 40pin Flat Rainbow Ribbon Cable
10 x 1kΩ Resistor
1 x Screwdriver
1 x T-Extension
9 x LED (3 red, 3 yellow, and 3 green)
12 x Screws(4 x M3*6 screws ,4 x PWM2*6 screw, 4 x PWM2*4 screws)